The standard set in MIB-II, together with the Ether-Like MIB, are supported
by default. The MIB files used to compile the handlers in the agent and to
“drive” the testing (snmpwalk et
al under LINUX)
are those acquired from that same UCD distribution.
These are the supported MIBs; all are below mib2 == 1.3.6.1.2.1:
system { mib2 1 }
interfaces { mib2 2 }
[ address-translation “at” { mib2 3 } is deprecated ]
ip { mib2 4 }
icmp { mib2 5 }
tcp { mib2 6 }
udp { mib2 7 }
[ exterior gateway protocol “egp” { mib2 8 } not supported ]
[ cmot { mib2 9 } is “historic”, just a placeholder ]
dot3 { mib2 10 7 } == { transmission 7 } “EtherLike MIB”
snmp { mib2 11 } |
On inclusion of SNMPv3 support packages, the following MIBs are added to the
default set of MIBs enumerated above :
snmpEngine { snmpFrameworkMIBObjects 1 } SNMP-FRAMEWORK-MIB, as described in
RFC-2571 for support of SNMPv3
framework.
usmStats { usmMIBObjects 1 } SNMP-USER-BASED-SM-MIB, as
usmUser { usmMIBObjects 2 } specified in RFC-2574 for support
of user based security model in
SNMPv3 management domains. |
